PANDATEL-ETC-MODEM-MIB
AI MIB Summary
Standard SNMP MIB module defining data structures for PANDATEL-ETC-MODEM-MIB.
21
Objects
Active
Status
4
Dependencies
Imported Objects
Objects
21 total| Object Name |
|---|
etc OBJECT IDENTIFIER .1.3.6.1.4.1.760.1.1.2.1.10.901 |
etcModemTableThe table of all ETC modems in this housing. SEQUENCE OF EtcTableEntry .1.3.6.1.4.1.760.1.1.2.1.10.901.1 |
etcTableEntryThe index of the table. EtcTableEntry .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1 |
mdmRackThe index of the rack where the modem is installed.ro INTEGER .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.1 |
mdmModemThis variable displays the slot number where the
corresponding modem is installed in the rack.ro INTEGER .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.2 |
mdmPositionThis variable displays the location of the corresponding
modem: 'local' or 'remote'.
The modem which is plugged into a managed rack is 'local',
the counterpart is 'remote'.ro Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.3 |
mdmModemNameA verbal name of this modem.ro DisplayString (SNMPv2-TC) .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.5 |
mdmDataEquipmentEmulationInterface mode of the unit: 'dte' or 'dce', 'te' or 'nt'.ro Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.6 |
mdmModemPropertyThe speed class of the unit: 'eth100base-tx-full-duplex'
or 'eth100base-tx-half-duplex'.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.7 |
mdmAlarmThe status of local alarm: 'off' or 'on'.ro Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.15 |
mdmRemoteAccessModeThe possibility of remote management: 'enabled', 'disabled local'
or 'disable local and remote'.
Once disabled management at local and remote unit, it is not possible
to enable it at the remote unit again.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.64 |
mdmForcedRemoteAccessActivation of remote management: 'on' or 'off'.
Status 'on' enables management of remote unit. During this
process the link is restricted to management data. The
transmission of user data is interrupted.
Status 'off' disables management of remote unit. The link
transmits user data.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.65 |
mdmOperationModeThe possibility of operation mode: 'normal', 'remote-fault-detection mode'
or 'link-pass-through'.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.66 |
mdmFoPowerThe status of transmitter power: 'low' or 'high'.ro Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.71 |
mdmAutoDetectModemPropertyThe status of auto detect of modem property: 'off' or 'on'.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.74 |
mdmInterfaceAlarmConditionThe alarm trigger mode at interface port: 'disable', i.e. no alarm
is triggered, 'no-link-signal', i.e. an alarm is triggered if
the link is down.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.98 |
mdmLineAlarmConditionThe alarm trigger mode at line port: 'disable', i.e. no alarm
is triggered, 'no-link-signal', i.e. an alarm is triggered if
the link is down, 'laser-fail', i.e. an alarm is triggered
if the laser diode is defective, or 'no-link-signal-or-laser-fail',
i.e. the link is down or the laser diode is defective.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.99 |
mdmStatusInterfacePortThe status 'disable': port is not active.
The status 'enable': port is active.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.140 |
mdmStatusLinePortThe status 'disable': port is not active.
The status 'enable': port is active.rw Enumeration .1.3.6.1.4.1.760.1.1.2.1.10.901.1.1.141 |
etc-modem OBJECT IDENTIFIER .1.3.6.1.4.1.760.1.1.2.1.10.10000.2.901 |
RFC1213-MIB Unknown .1.3.6.1.4.1.760.1.1.2.1.10.10000.2.901 |