GENERICOBJECT-MIB
Detailed view of the defined objects, syntax rules, and hierarchical paths.
Imported Objects
Objects
5 total| Object Name |
|---|
genericObjects OBJECT IDENTIFIER .1.3.6.1.4.1.351.110.2.8 |
IMPORTS Unknown .1.3.6.1.4.1.351.110.2.8 |
genericLineNumThis is the generic line number used in traps. This object
cannot be set or read. This object may refer to a T1, T3
or X21 line. (It is a proxy for other objects lineNum,
dsx3LineNum and x21LineNum).
Currently, the ranges are
T1/E1 1..56
T3/E3 1..3
X21 1..4ro INTEGER .1.3.6.1.4.1.351.110.2.8.1 |
genericLineTypeThis is the generic line type used in traps. This object
cannot be set or read. Depending on the value, this object
may refer to a T1, T3 or X21 line type.
It is a proxy for other objects lineType, dsx3LineType and
x21LineType.ro Enumeration .1.3.6.1.4.1.351.110.2.8.2 |
genericTimeStampThis is the generic time stamp used in traps. This object
cannot be set or read. This object will be used by all new
traps to tell the time that a given trap was originated.ro DisplayString .1.3.6.1.4.1.351.110.2.8.3 |
More MIBs from Stratacom
Browse all StratacomMIBs →Standard SNMP MIB module defining data structures for CISCO-WAN-AXIPOP-MIB.
Standard SNMP MIB module defining data structures for STRATACOM-MIB.
The CISCO-WAN-SVC-MIB manages ATM service provisioning, configuration, and status monitoring on Cisco BPX-SES and MGX ATM switches, specifically tracking XPVC/XPVP segments, OAM cell handling, and ENNI auto-discovery via ILMI. It facilitates the administration of ATM traffic classes (CBR, VBR, UBR, ABR) and virtual circuit states (SVC, SPVC) across User-Network and Network-Network interfaces.
Standard SNMP MIB module defining data structures for CISCO-MGX82XX-SONET-MIB.
The CISCO-MGX82XX-DSX3-MIB enables configuration and monitoring of DS3/E3 interface parameters, including alarm states (AIS, LOF, RAI), performance statistics, and Bit Error Rate Testing (BERT) on Cisco MGX 8220/8230 T3/E3 service modules such as the CESM-T3E3 and FRSM-VHS. This module facilitates the management of physical layer convergence procedures (PLCP) and maintenance byte fields (Tx/Rx MA) defined by ITU-T G.832 for channelized T3 and E3 circuits.
The CISCO-WAN-PAR-MIB manages the Portable AutoRoute (PAR) controller on Cisco MGX and BPX switches to provision, monitor, and alarm connections while controlling LMI communication and clocking selection. It enables the configuration of routing capabilities, failure event conditioning, and the management of feeder-to-node signaling and switch synchronization.