Fore-TC-MIB
This mib implements management information for the ATM traffic convergence layer in an atm interface.
Main OID:
foreTcMib.1.3.6.1.4.1.326.2.2.1.1.12
32
Objects
Active
Status
4
Dependencies
Imported Objects
Objects
32 total| Object Name |
|---|
foreTcMibThis mib implements management information for the ATM traffic convergence layer in an atm interface. MODULE-IDENTITY .1.3.6.1.4.1.326.2.2.1.1.12 |
foreTcLCDDetectedThis trap indicates that the specified SONET port is experiencing Loss of Cell Deliniation (LCD). A LCD failure is declared when the LCD defect persists for a period of 2.5 +/- 0.5 seconds. NOTIFICATION-TYPE .1.3.6.1.4.1.326.2.2.1.1.12.0.1 |
foreTcLCDClearedThis trap indicates that the LCD failure identified by trap asxSonetAtmLCDDetected has been cleared. A LCD failure is cleared when the LCD defect is absent for 10 +/- 0.5 seconds. NOTIFICATION-TYPE .1.3.6.1.4.1.326.2.2.1.1.12.0.2 |
foreTcConfigTableA table of ATM Cell Convergence Layer configuration parameters. SEQUENCE OF ForeTcConfigEntry .1.3.6.1.4.1.326.2.2.1.1.12.1 |
foreTcConfigEntryA table entry containing ATM Cell convergence layer configuration information for each atm interface. ForeTcConfigEntry .1.3.6.1.4.1.326.2.2.1.1.12.1.1 |
foreTcConfigCellScramblingThis variable indicates if cell payload scrambling is enabled. If enabled, all outgoing cell payloads are scrambled via the X**43+1 generator polynomial as defined in ITU I.432.1 and all incoming cell payloads are descrambled by the same mechanism.rw Enumeration .1.3.6.1.4.1.326.2.2.1.1.12.1.1.1 |
foreTcConfigEmptyCellThis variable indicates the type of ATM cells inserted into the outgoing data stream when there is no real data to send. There are two choices: idle -> All bits 0 except that CLP is set to 1 unassigned -> All bits 0 The default value is to send unassigned cells.rw Enumeration .1.3.6.1.4.1.326.2.2.1.1.12.1.1.2 |
foreTcConfigLoopbackThis variable indicates if cell loopback is enabled at the TC layer. There are three choices: tcNoLoop - Normal operating mode, cells are passed through. tcDiagLoop - Diagnostic mode. Transmitted cells are looped back to the ATM interface. tcPayloadLoop - Payload Loopback. Received cells are looped back to the Phy port.rw Enumeration .1.3.6.1.4.1.326.2.2.1.1.12.1.1.3 |
foreTcConfigFramingModeThis variable configures and indicates the method used to encapsulate ATM cells in the data stream. There are two choices: tcFramingDirect - Direct insertion of cells into the data stream. tcFramingPlcp - Use PLCP framing. Typically this is used on T1/E1 and T3/E3 lines. Not all interfaces may support all modes. It is possible on some interfaces, for example Sonet, that this is implemented as a read-only variable set to tcFramingDirect.rw Enumeration .1.3.6.1.4.1.326.2.2.1.1.12.1.1.4 |
foreTcConfigStatusThis variable indicates the ATM Status of the interface. The variable is a bit map represented as a sum, therefore it can represent multiple defects simultaneously. The sonetAtmNoDefect should be set if and only if no other flag is set. The various bit mask values are: 1 sonetAtmNoDefect 2 sonetAtmLCD Loss of Cell Delineation was detected. LCD is declared when a 'normal pointer value' is not found for eight consecutive frames. 4 sonetAtmPlcpLOF Valid PLCP frames were not detected at the interface. 8 sonetAtmPlcpYellow Plcp Yellow alarm was detected in the incoming PLCP frame stream.ro Integer32 .1.3.6.1.4.1.326.2.2.1.1.12.1.1.5 |
foreTcTotalTableA table of ATM Cell Convergence Layer statistics. SEQUENCE OF ForeTcTotalEntry .1.3.6.1.4.1.326.2.2.1.1.12.2 |
foreTcTotalEntryA table entry containing ATM Cell convergence layer statistics for each atm interface. ForeTcTotalEntry .1.3.6.1.4.1.326.2.2.1.1.12.2.1 |
foreTcTotalLcdSecondsThe number of seconds in which the LCD (loss of cell delineation) defect occured. An LCD defect is detected when an out of cell delineation state has persisted for 4ms. The defect is cleared when sync state has been maintained for 4ms.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.2.1.1 |
foreTcTotalCorrectableHcsThe number of correctable Header Check Sequence (HCS) error events that have occured since the port has been reset.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.2.1.2 |
foreTcTotalUncorrectableHcsThe number of uncorrectable Header Check Sequence (HCS) error events that have occured since the port has been reset.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.2.1.3 |
foreTcTotalTxCellsThe number of cells that were transmitted for this atm interface.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.2.1.4 |
foreTcTotalRxCellsThe number of cells that were received on this atm interface.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.2.1.5 |
foreTcCurrentTableA table of ATM Cell Convergence Layer statistics. SEQUENCE OF ForeTcCurrentEntry .1.3.6.1.4.1.326.2.2.1.1.12.4 |
foreTcCurrentEntryA table entry containing ATM Cell convergence layer statistics for each atm interface. ForeTcCurrentEntry .1.3.6.1.4.1.326.2.2.1.1.12.4.1 |
foreTcCurrentErrSecondsNumber of Errored Secondsro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.4.1.1 |
foreTcCurrentSevErrSecondsNumber of Severely Errored Secondsro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.4.1.2 |
foreTcCurrentUnavailSecondsNumber of Unavailable Secondsro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.4.1.3 |
foreTcCurrentCorrectableHcsThe number of correctable Header Check Sequence (HCS) error events that have occured since the port has been reset.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.4.1.4 |
foreTcCurrentUncorrectableHcsThe number of uncorrectable Header Check Sequence (HCS) error events that have occured since the port has been reset.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.4.1.5 |
foreTcIntervalTableA table of ATM Cell Convergence Layer statistics. SEQUENCE OF ForeTcIntervalEntry .1.3.6.1.4.1.326.2.2.1.1.12.5 |
foreTcIntervalEntryA table entry containing ATM Cell convergence layer statistics for each atm interface. ForeTcIntervalEntry .1.3.6.1.4.1.326.2.2.1.1.12.5.1 |
foreTcIntervalInterval numberro Integer32 .1.3.6.1.4.1.326.2.2.1.1.12.5.1.1 |
foreTcIntervalErrSecondsNumber of Errored Secondsro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.5.1.2 |
foreTcIntervalSevErrSecondsNumber of Severely Errored Secondsro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.5.1.3 |
foreTcIntervalUnavailSecondsNumber of Unavailable Secondsro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.5.1.4 |
foreTcIntervalCorrectableHcsThe number of correctable Header Check Sequence (HCS) error events that have occured since the port has been reset.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.5.1.5 |
foreTcIntervalUncorrectableHcsThe number of uncorrectable Header Check Sequence (HCS) error events that have occured since the port has been reset.ro Counter32 .1.3.6.1.4.1.326.2.2.1.1.12.5.1.6 |