CISCO-WAN-VISM-XGCP-CAPABILITY
The CISCO-WAN-VISM-XGCP-CAPABILITY MIB module defines agent capabilities for monitoring XGCP (eXtended Gigabit Channelized Protocol) session states, link status, and performance counters on Cisco WAN VISM (Virtual Service Interface Module) hardware. It enables network management systems to retrieve specific protocol state information and operational metrics required for troubleshooting and maintaining XGCP-based WAN services.
Imported Objects
Objects
4 total| Object Name |
|---|
ciscoWanVismXgcpCapabilityThe Agent Capabilities for XGCP-MIB. MODULE-IDENTITY .1.3.6.1.4.1.351.160.322 |
ciscoWanVismXgcpCapabilityV2R00XGCP MIB Capabilities Unknown .1.3.6.1.4.1.351.160.322.1 |
ciscoWanVismXgcpCapabilityV2R01XGCP MIB Capabilities Unknown .1.3.6.1.4.1.351.160.322.2 |
ciscoWanVismXgcpCapabilityV3R00XGCP MIB Capabilities Unknown .1.3.6.1.4.1.351.160.322.3 |
More MIBs from Stratacom
Browse all StratacomMIBs →Standard SNMP MIB module defining data structures for CISCO-WAN-AXIPOP-MIB.
Standard SNMP MIB module defining data structures for STRATACOM-MIB.
The CISCO-WAN-SVC-MIB manages ATM service provisioning, configuration, and status monitoring on Cisco BPX-SES and MGX ATM switches, specifically tracking XPVC/XPVP segments, OAM cell handling, and ENNI auto-discovery via ILMI. It facilitates the administration of ATM traffic classes (CBR, VBR, UBR, ABR) and virtual circuit states (SVC, SPVC) across User-Network and Network-Network interfaces.
Standard SNMP MIB module defining data structures for CISCO-MGX82XX-SONET-MIB.
The CISCO-MGX82XX-DSX3-MIB enables configuration and monitoring of DS3/E3 interface parameters, including alarm states (AIS, LOF, RAI), performance statistics, and Bit Error Rate Testing (BERT) on Cisco MGX 8220/8230 T3/E3 service modules such as the CESM-T3E3 and FRSM-VHS. This module facilitates the management of physical layer convergence procedures (PLCP) and maintenance byte fields (Tx/Rx MA) defined by ITU-T G.832 for channelized T3 and E3 circuits.
The CISCO-WAN-PAR-MIB manages the Portable AutoRoute (PAR) controller on Cisco MGX and BPX switches to provision, monitor, and alarm connections while controlling LMI communication and clocking selection. It enables the configuration of routing capabilities, failure event conditioning, and the management of feeder-to-node signaling and switch synchronization.