Unisphere-Data-PPP-PROFILE-MIB
AI MIB Summary
The Unisphere-Data-PPP-PROFILE-MIB manages Point-to-Point Protocol interface configurations and profile parameters within Dell EMC Unisphere storage systems, extending the base PROFILE-MIB to define PPP-specific attributes such as authentication methods, link control protocol settings, and interface state variables.
The Point-to-Point Protocol (PPP) Profile MIB for the Unisphere Netowrks enterprise. This MIB provides configuration parameters that extend the tables found in the Unisphere-Data-PROFILE-MIB to support profiles for PPP interfaces.
Main OID:
usdPppProfileMIB.1.3.6.1.4.1.4874.2.2.45
32
Objects
Active
Status
5
Dependencies
Imported Objects
Objects
32 total| Object Name |
|---|
usdPppProfileMIBThe Point-to-Point Protocol (PPP) Profile MIB for the Unisphere Netowrks enterprise. This MIB provides configuration parameters that extend the tables found in the Unisphere-Data-PROFILE-MIB to support profiles for PPP interfaces. MODULE-IDENTITY .1.3.6.1.4.1.4874.2.2.45 |
usdPppProfileObjects OBJECT IDENTIFIER .1.3.6.1.4.1.4874.2.2.45.1 |
usdPppProfile OBJECT IDENTIFIER .1.3.6.1.4.1.4874.2.2.45.1.1 |
usdPppProfileTableThis table contains profiles for configuring PPP interfaces. Entries in this table are created/deleted as a side-effect of corresponding operations to the usdProfileNameTable in the Unisphere-Data-PROFILE-MIB. SEQUENCE OF UsdPppProfileEntry .1.3.6.1.4.1.4874.2.2.45.1.1.1 |
usdPppProfileEntryA profile describing configuration of a PPP interface. UsdPppProfileEntry .1.3.6.1.4.1.4874.2.2.45.1.1.1.1 |
usdPppProfileIdThe integer identifier associated with this profile. A value for this identifier is determined by locating or creating a profile name in the Unisphere-Data-PROFILE-MIB.usdProfileNameTable. Unsigned32 .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.1 |
usdPppProfileSetMapA bitmap representing which objects in this entry have been explicitly configured. See the definition of the UsdSetMap TEXTUAL-CONVENTION for details of use. The INDEX object(s) and this object are excluded from representation (i.e. their bits are never set). When a SET request does not explicitly configure UsdSetMap, bits in UsdSetMap are set as a side-effect of configuring other profile attributes in the same entry. If, however, a SET request explicitly configures UsdSetMap, the explicitly configured value overrides 1) any previous bit settings, and 2) any simultaneous 'side-effect' settings that would otherwise occur. Once set, bits can only be cleared by explicitly configuring UsdSetMap.rw UsdSetMap (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.2 |
usdPppProfileLcpMagicNumberIf true(2) then the local node will attempt to perform Magic Number negotiation with the remote node. If false(1) then this negotiation is not performed. In any event, the local node will comply with any magic number negotiations attempted by the remote node, per the PPP specification.rw Enumeration .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.3 |
usdPppProfileLcpKeepaliveKeepalive interval in seconds. A value of zero disables keepalive. Keepalive is performed using LCP Echo.rw Integer32 (0|30..300) UNITS "seconds" .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.4 |
usdPppProfileLcpAuthenticationSpecifies the type(s) of authentication, if any, to be negotiated with the peer: none No authentication is negotiated. pap PAP negotiation only. chap CHAP negotiation only. papChap PAP negotiation is attempted first; if fails, attempt CHAP. chapPap CHAP negotiation is attempted first; if fails, attempt PAP. Setting this object to none will set usdPppProfileAuthenticatorVirtualRouter object to an empty string.rw UsdPppAuthentication (Unisphere-Data-PPP-MIB) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.5 |
usdPppProfileIpPeerDnsPriorityWhen enabled, allows peer's DNS address to prevail in the event of a negotiation conflict; when disabled, the local PPP interface's DNS address prevails.rw UsdEnable (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.6 |
usdPppProfileIpPeerWinsPriorityWhen enabled, allows peer's WINS address to prevail in the event of a negotiation conflict; when disabled, the local PPP interface's WINS address prevails.rw UsdEnable (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.7 |
usdPppProfileLcpInitialMRUThe initial Maximum Receive Unit (MRU) that the local PPP entity will advertise to the remote entity. If the value of this variable is 1 then the local PPP entity will advertise an MRU value determined by its underlying media interface.rw INTEGER (1|64..65535) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.8 |
usdPppProfilePacketLogWhen enabled, allows packet logging on dynamic PPP interfaces.rw UsdEnable (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.9 |
usdPppProfileStateLogWhen enabled, allows state machine logging on dynamic PPP interfaces.rw UsdEnable (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.10 |
usdPppProfileChapMinChallengeLengthMinimum value of the CHAP authenticator challenge length value. This value is never allowed to be set to a value greater than usdPppProfileChapMaxChallengeLength.rw INTEGER .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.11 |
usdPppProfileChapMaxChallengeLengthMaximum value of the CHAP authenticator challenge length value. This value is never allowed to be set to a value less than usdPppLinkConfigChapMinChallengeLength.rw INTEGER .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.12 |
usdPppProfilePassiveModeWhen enabled, LCP state machine is forced into passive mode on lower layer UP message. It adds compatibility with slow and buggy clients.rw UsdEnable (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.13 |
usdPppProfileMlpppEnables the creation of dynamic multi-link PPP interfaces.rw UsdEnable (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.14 |
usdPppProfileIpcpNetmaskEnables the negotiation of the IPCP option netmask (0x90) during IPCP negotiation.rw UsdEnable (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.15 |
usdPppProfileAuthenticatorVirtualRouterThe name of the virtual router (Unisphere-Data-ROUTER-MIB.usdRouterName) to be used for authentication on the PPP interface. Setting this object statically binds the authenticating virtual router with the PPP interface. If this object is not explicitly set or it is set to null string, then this object is ignored and the virtual router used for authentication is determined by other means. On a Set operation, if the value of this object is not null and does not correspond to an existing virtual router, then an inconsistentValue error is returned. Setting this object to non null string returns inconsistentValue value error if usdPppProfileConfigAuthentication object is none or not configured.rw UsdName (Unisphere-Data-TC) .1.3.6.1.4.1.4874.2.2.45.1.1.1.1.16 |
usdPppProfileConformance OBJECT IDENTIFIER .1.3.6.1.4.1.4874.2.2.45.4 |
usdPppProfileCompliances OBJECT IDENTIFIER .1.3.6.1.4.1.4874.2.2.45.4.1 |
usdPppProfileComplianceObsolete compliance statement for entities which implement the Unisphere PPP Profile MIB. This statement became obsolete when support was added for multi-link PPP interfaces.obsolete Unknown .1.3.6.1.4.1.4874.2.2.45.4.1.1 |
usdPppProfileCompliance2Obsolete compliance statement for entities which implement the Unisphere PPP Profile MIB. This statement became obsolete when support was added for negotiation of IPCP option netmask.obsolete Unknown .1.3.6.1.4.1.4874.2.2.45.4.1.2 |
usdPppProfileCompliance3Obsolete compliance statement for entities which implement the Unisphere PPP Profile MIB. This statement became obsolete when the usdPppProfileAuthenticatorVirtualRouter object was added.obsolete Unknown .1.3.6.1.4.1.4874.2.2.45.4.1.3 |
usdPppProfileCompliance4The compliance statement for entities which implement the Unisphere PPP Profile MIB. Unknown .1.3.6.1.4.1.4874.2.2.45.4.1.4 |
usdPppProfileGroups OBJECT IDENTIFIER .1.3.6.1.4.1.4874.2.2.45.4.2 |
usdPppProfileGroupObsolete collection of objects providing management of profile functionality for PPP interfaces in a Unisphere product. This group became obsolete when support was added for MLPPP.obsolete Unknown .1.3.6.1.4.1.4874.2.2.45.4.2.1 |
usdPppProfileGroup2Obsolete collection of objects providing management of profile functionality for PPP interfaces in a Unisphere product. This group became obsolete when support was added for negotiation of IPCP option netmask.obsolete Unknown .1.3.6.1.4.1.4874.2.2.45.4.2.2 |
usdPppProfileGroup3Obsolete collection of objects providing management of profile functionality for PPP interfaces in a Unisphere product. This group became obsolete when the usdPppProfileAuthenticatorVirtualRouter object was added.obsolete Unknown .1.3.6.1.4.1.4874.2.2.45.4.2.3 |
usdPppProfileGroup4A collection of objects providing management of profile functionality for PPP interfaces in a Unisphere product. Unknown .1.3.6.1.4.1.4874.2.2.45.4.2.4 |
More MIBs from Unisphere
Browse all UnisphereMIBs →Juniper-BGP-MIB
SNMP MIB module
673 objects→
Unisphere-Data-BGP-MIB
The Unisphere-Data-BGP-MIB enables monitoring and management of Border Gateway Protocol (BGP) session states, routing table statistics, and neighbor relationships on Dell EMC Unisphere for Data storage systems. It provides access to standard BGP MIB objects for tracking peer connectivity, route advertisements, and protocol error counters within the storage network infrastructure.
466 objects→
Juniper-RADIUS-CLIENT-MIB
The Juniper-RADIUS-CLIENT-MIB enables monitoring of RADIUS client authentication sessions, accounting records, and server reachability states on Juniper network devices. It provides specific counters and gauges for tracking authentication failures, successful logins, and RADIUS server response times to validate access control infrastructure health.
397 objects→
Juniper-UNI-ATM-MIB
The Juniper-UNI-ATM-MIB module provides SNMP management capabilities for Juniper devices configured with Asynchronous Transfer Mode (ATM) user-network interfaces, enabling the monitoring of ATM-specific performance counters, interface states, and VPI/VCI traffic statistics.
380 objects→
Juniper-AAA-MIB
The Juniper-AAA-MIB enables monitoring of authentication, authorization, and accounting events on Juniper Networks devices, specifically tracking user session states, login success/failure counts, and accounting record generation for RADIUS and TACACS+ protocols.
362 objects→
Juniper-POLICY-MIB
SNMP MIB module
348 objects→