PAIRGAIN-DSLAM-CHASSIS-MIB
AI MIB Summary
Standard SNMP MIB module defining data structures for PAIRGAIN-DSLAM-CHASSIS-MIB.
40
Objects
Active
Status
4
Dependencies
Imported Objects
Objects
40 total| Object Name |
|---|
RFC1155-SMIThe value of the pgDSLAMCalendarTime object at which a specific
occurrence happened. The specific occurrence must be
defined in the description of any object defined using this
type.ro INTEGER .1.3.6.1.4.1.927.1.9.1.1 |
pgDSLAMChassisPsStatusThe chassis power supply status.ro Enumeration .1.3.6.1.4.1.927.1.9.1.2 |
pgDSLAMChassisFanStatusThe status of the chassis cooling fan.ro Enumeration .1.3.6.1.4.1.927.1.9.1.3 |
pgDSLAMSlotConfigTableThe DSLAM chassis slot configuration table. SEQUENCE OF PgDSLAMSlotConfigEntry .1.3.6.1.4.1.927.1.9.1.4 |
pgDSLAMSlotConfigEntryEntry in the DSLAM slot configuration table. PgDSLAMSlotConfigEntry .1.3.6.1.4.1.927.1.9.1.4.1 |
pgDSLAMSlotNumberThe chassis slot number. Valid entries are 1-21.
The slots are numbered from left to right
from 1-21. The DMU is always located in slot 1ro INTEGER .1.3.6.1.4.1.927.1.9.1.4.1.1 |
pgDSLAMSlotUnitTypeThe type of Unit this entry represents.ro PgDSLAMUnitType .1.3.6.1.4.1.927.1.9.1.4.1.2 |
pgDSLAMSlotUnitSerialNoSerial number of the Unit.ro DisplayString .1.3.6.1.4.1.927.1.9.1.4.1.3 |
pgDSLAMSlotUnitDescrUnit description.rw DisplayString .1.3.6.1.4.1.927.1.9.1.4.1.4 |
pgDSLAMSlotHwVerThe hardware revision of the board.ro DisplayString .1.3.6.1.4.1.927.1.9.1.4.1.5 |
pgDSLAMSlotFwVerThe firmware revision of the board.ro DisplayString .1.3.6.1.4.1.927.1.9.1.4.1.6 |
pgDSLAMSlotSwVerThe software revision of the board.ro DisplayString .1.3.6.1.4.1.927.1.9.1.4.1.7 |
pgDSLAMSlotBoardResetThis indicates the reset state of the board. Writing with
the value reset (2) will reset the board.rw Enumeration .1.3.6.1.4.1.927.1.9.1.4.1.8 |
pgDSLAMSlotNmCntlStatusTells whether the board is under network management control.ro Enumeration .1.3.6.1.4.1.927.1.9.1.4.1.9 |
pgDSLAMSlotIfNumberThe number of MIB-II ifEntry maintained by this board.ro INTEGER .1.3.6.1.4.1.927.1.9.1.4.1.10 |
pgDSLAMSlotHwIDThe hardware identification number of the board.ro DisplayString .1.3.6.1.4.1.927.1.9.1.4.1.11 |
pgDSLAMConfigChangeCntsThe number of times a physical configuration change has
taken place in the chassis such as the insertion/deinsertion
of a Unit. Any events causing a change in the pgDSLAMSlotConfigTable
or the pgDSLAMCommonBoardTable should cause this counter to be
incremented.ro Counter .1.3.6.1.4.1.927.1.9.1.5 |
pgDSLAMConfigLastChangeThe value of sysUpTime at the time the most recent physical
configuration change occurred.ro TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.927.1.9.1.6 |
pgDSLAMChassisAlarmStatTableThis table maintains the latest alarm status provided by each channel or line
card in the chassis. There is only one alarm status entry per card. That means
that the subsequent alarm status generated by the same card will overwrite the
previous status stored in the correspondent entry. SEQUENCE OF DSLAMAlarmStatEntry .1.3.6.1.4.1.927.1.9.1.7 |
dslamAlarmStatEntryAn entry contains the latest alarm status for a channel or line card. DSLAMAlarmStatEntry .1.3.6.1.4.1.927.1.9.1.7.1 |
pgDSLAMAlarmCardIDThe slot containing the card which generates this alarm.ro INTEGER .1.3.6.1.4.1.927.1.9.1.7.1.1 |
pgDSLAMAlarmPortNumTogether with the pgDSLAMAlarmCardID this object uniquely identify a port which
an alarm condition was detected.ro INTEGER .1.3.6.1.4.1.927.1.9.1.7.1.2 |
pgDSLAMAlarmStatSeverityThe severity of the alarm reported by the channel or line card.ro Enumeration .1.3.6.1.4.1.927.1.9.1.7.1.3 |
pgDSLAMAlarmTrapOIDThe value of this object uniquely identify the type of alarm generated by the
channel or line card. It is the same trap OID used to generate the SNMP trap
when the alarm threshold value was exceeded.ro OBJECT IDENTIFIER .1.3.6.1.4.1.927.1.9.1.7.1.4 |
pgDSLAMChassisLEDStatThe octet within the value of this object specifies a set of
eight LEDs. Within the octet, each bit represents the status
of a LED on the front panel. Following is the bit-map:
Lower octet:
bit 0 : critical alarm LED
bit 1 : major alarm LED
bit 2 : minor alarm LED
bit 3 : power minor alarm LED
bit 4 : input power 1
bit 5 : input power 2
bit 6 : fuse alarm 1
bit 7 : fuse alarm 2
Upper octet:
bit 0 : Alarm Cut Off
bit 1 : abnormal
bit 2 : fault
bit 3 : external alarm
bit 4 : fan alarm 1
bit 5 : fan alarm 2
bit 6 : fan alarm 3
bit 7 : fan alarm 4
If a bit has a value of '1' then the correspondant LED is
on and '0' is off.ro OCTET STRING .1.3.6.1.4.1.927.1.9.1.8 |
pgDSLAMCalendarTimeThe current date and time indicated by seconds
since 1900.1.1 00:00:00rw Counter .1.3.6.1.4.1.927.1.9.1.9 |
pgDSLAMSlotStatTableThe state of slots within this chassis. SEQUENCE OF DSLAMSLOTStatEntry .1.3.6.1.4.1.927.1.9.1.10 |
pgDSLAMSlotStatEntryAn entry contains the information of a specified slot. DSLAMSLOTStatEntry .1.3.6.1.4.1.927.1.9.1.10.1 |
pgDSLAMSlotIDThe slot number.ro INTEGER .1.3.6.1.4.1.927.1.9.1.10.1.1 |
pgDSLAMSlotStatusThe status of the specified slot.
unknown - uncertain state.
up - the card plugged in this slot is up and running.
down - the card is not functioning.
notPresent - there is no card plugged in this slot.ro Enumeration .1.3.6.1.4.1.927.1.9.1.10.1.2 |
pgDSLAMChassisTemperatureThe current temperature inside the chassis in Centigrade.ro INTEGER .1.3.6.1.4.1.927.1.9.1.11 |
pgDSLAMFileDirectoryTableThe file directory for each slot. SEQUENCE OF PgDSLAMFileDirectoryEntry .1.3.6.1.4.1.927.1.9.1.12 |
pgDSLAMFileDirectoryEntryAn entry contains the file directory of a specified slot. PgDSLAMFileDirectoryEntry .1.3.6.1.4.1.927.1.9.1.12.1 |
pgDSLAMFileDirectorySlotIDThe slot number for the file directory.ro INTEGER .1.3.6.1.4.1.927.1.9.1.12.1.1 |
pgDSLAMFileDirectoryThe file directory.ro OCTET STRING .1.3.6.1.4.1.927.1.9.1.12.1.2 |
pgDSLAMFsSlotIDThe slot number for the file operation.rw INTEGER .1.3.6.1.4.1.927.1.9.1.13 |
pgDSLAMFsFileNameThe file name for the file operation.rw OCTET STRING .1.3.6.1.4.1.927.1.9.1.14 |
pgDSLAMFsActionThe action for the file operation.rw Enumeration .1.3.6.1.4.1.927.1.9.1.15 |
pgDSLAMCalendarTimeOsA date-time format.
field octets contents range
-
1 1-2 year 0..65536
2 3 month 1..12
3 4 day 1..31
4 5 hour 0..23
5 6 minutes 0..59
6 7 seconds 0..60
For example, Tuesday May 26, 1992 at 1:30:15 PM would be
displayed as: 1992-5-26,13:30:15rw OCTET STRING .1.3.6.1.4.1.927.1.9.1.16 |
pgDSLAMAllSlotLEDThis object reflects the current status of all the front panel LED's
on all the slot of the Avidia Shelf.
The Semantics of the octet-string is as described below.
It is set of following structure.
First Octet - SlotID
Second Octet - CardType PgDSLAMUnitType
Third Octet - Number of Bytes Used by the Slot LED Status.
Fourth Octet - Status of LED for port1
Fifth Octet - Status of LED for port2
....
....
till depending on the Number of port on the card.
LED Status in encoded as a bit map described below
Bits 0-3 represent the State (0000-off,0001-on,0011-Blinking)
Bits 4-7 represent the Color (0000-clear,0001-green,0011-yellow,0100-red)
For AMC two octet will be used to represent the LED Status
Lower octet:
bit 0 : critical alarm LED
bit 1 : major alarm LED
bit 2 : minor alarm LED
bit 3 : power minor alarm LED
bit 4 : input power 1
bit 5 : input power 2
bit 6 : fuse alarm 1
bit 7 : fuse alarm 2
Upper octet:
bit 0 : Alarm Cut Off
bit 1 : abnormal
bit 2 : fault
bit 3 : external alarm
bit 4 : fan alarm 1
bit 5 : fan alarm 2
bit 6 : fan alarm 3
bit 7 : fan alarm 4
If a bit has a value of '1' then the correspondant LED is
on and '0' is off.
For OC-3 each port will have three LED's Tx,Rx,Sync and one APSro OCTET STRING .1.3.6.1.4.1.927.1.9.1.17 |