NETGEAR-NSF-MIB
The NETGEAR-NSF-MIB module enables SNMP-based configuration and status monitoring of Non-Stop Forwarding (NSF) capabilities within NETGEAR FastPath routing engines. It exposes specific metrics regarding NSF session synchronization states, failover readiness, and the operational integrity of the control plane during routing protocol restarts.
Imported Objects
Objects
30 total| Object Name |
|---|
fastPathNsfThis MIB defines the objects used for FastPath to
configure and report information and status of NSF features. MODULE-IDENTITY .1.3.6.1.4.1.4526.10.46 |
agentNsfTraps OBJECT IDENTIFIER .1.3.6.1.4.1.4526.10.46.0 |
agentNsfChassisRestartCompleteSent when the chassis finishes restarting after a failover. NOTIFICATION-TYPE .1.3.6.1.4.1.4526.10.46.0.2 |
agentNsfUnitTableA table of Per-Unit configuration objects for NSF. SEQUENCE OF AgentNsfUnitEntry .1.3.6.1.4.1.4526.10.46.1 |
agentNsfUnitEntryEach Instance corresponds with a different unit managed by this agent. AgentNsfUnitEntry .1.3.6.1.4.1.4526.10.46.1.1 |
agentNsfUnitSupportIndicates if the unit supports the NSF feature.ro TruthValue (SNMPv2-TC) .1.3.6.1.4.1.4526.10.46.1.1.1 |
agentNsfGroup OBJECT IDENTIFIER .1.3.6.1.4.1.4526.10.46.2 |
agentNsfOperStatusIndicates whether NSF is enabled on the unit/chassis.ro Enumeration .1.3.6.1.4.1.4526.10.46.2.2 |
agentNsfLastStartupReasonThe type of activation that caused the software to start the last time.
unknown: The switch rebooted for an unknown reason.
power-on: The switch rebooted. This could have been caused by a power
cycle or an administrative 'Reload' command.
warm-admin-move: The administrator issued a command for the stand-by manager to
take over.
cold-admin-move: The administrator issued a command for the stand-by manager to
take over, but the system was not ready for a warm-failover.
warm-auto-restart: The primary management card restarted due to a failure, and the
system executed a nonstop forwarding failover.
cold-auto-restart: The system switched from the active manager to the backup manager
and was unable to maintain user data traffic. This is usually
caused by multiple failures occurring close togetherro Enumeration .1.3.6.1.4.1.4526.10.46.2.3 |
agentNsfTimeSinceLastRestartTime since the current management card became the active management card.ro TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.4526.10.46.2.4 |
agentNsfRestartInProgressWhether a restart is in progress. A restart is not considered complete until all
hardware tables have been fully reconciled.ro TruthValue (SNMPv2-TC) .1.3.6.1.4.1.4526.10.46.2.5 |
agentNsfWarmRestartReadyWhether the initial full checkpoint has finished.ro TruthValue (SNMPv2-TC) .1.3.6.1.4.1.4526.10.46.2.6 |
agentNsfBackupConfigurationAgeAge of the configuration on the backup unit. The time since the running configuration
was last copied to the backup unit.ro TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.4526.10.46.2.7 |
agentNsfInitiateFailoverTriggers an administrative failover to the backup unit.rw Enumeration .1.3.6.1.4.1.4526.10.46.2.8 |
agentCheckpointStatsGroup OBJECT IDENTIFIER .1.3.6.1.4.1.4526.10.46.3 |
agentCheckpointClearStatisticsWhen set to enable(1), resets checkpoint statistics.rw Enumeration .1.3.6.1.4.1.4526.10.46.3.1 |
agentCheckpointMessagesTotal number of checkpoint messages sent.ro Counter32 .1.3.6.1.4.1.4526.10.46.3.2 |
agentCheckpointBytesSize in bytes of the total ammount of checkpoint messages sent.ro Counter32 .1.3.6.1.4.1.4526.10.46.3.3 |
agentCheckpointTimeSinceCountersClearedIndicates how long since the Checkpoint counters have been cleared.ro TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.4526.10.46.3.4 |
agentCheckpointMessageRateIntervalIndicates the duration in seconds of the message rate interval.ro Unsigned32 UNITS "seconds" .1.3.6.1.4.1.4526.10.46.3.5 |
agentCheckpointMessageRateNumber of checkpoint messages received in the last interval defined by
agentCheckpointMessageRateInterval.ro Gauge32 .1.3.6.1.4.1.4526.10.46.3.6 |
agentCheckpointHighestMessageRateHighest number of checkpoint messages received in an interval defined by
agentCheckpointMessageRateInterval.ro Gauge32 .1.3.6.1.4.1.4526.10.46.3.7 |
agentNsfOspfGroup OBJECT IDENTIFIER .1.3.6.1.4.1.4526.10.46.4 |
agentNsfOspfSupportModerw Enumeration .1.3.6.1.4.1.4526.10.46.4.1 |
agentNsfOspfRestartIntervalrw Unsigned32 .1.3.6.1.4.1.4526.10.46.4.2 |
agentNsfOspfRestartStatusro Enumeration .1.3.6.1.4.1.4526.10.46.4.3 |
agentNsfOspfRestartAgero TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.4526.10.46.4.4 |
agentNsfOspfRestartExitReasonro Enumeration .1.3.6.1.4.1.4526.10.46.4.5 |
agentNsfOspfHelperSupportModerw Enumeration .1.3.6.1.4.1.4526.10.46.4.6 |
agentNsfOspfHelperStrictLSACheckingrw Enumeration .1.3.6.1.4.1.4526.10.46.4.7 |
More MIBs from Netgear
Browse all NetgearMIBs →Standard SNMP MIB module defining data structures for WING-MIB.
The FASTPATH-SWITCHING-MIB enables monitoring and management of Netgear FastPath switching hardware, specifically exposing metrics related to Layer 2 forwarding tables, MAC address aging, VLAN configurations, and port statistics. This private MIB facilitates the tracking of switching plane performance and state changes within Netgear's proprietary FastPath operating environment.
The NETGEAR-SMART-SWITCHING-MIB provides vendor-specific OID extensions for monitoring and managing Layer 2 switching functions, including port status, MAC address tables, VLAN configurations, and spanning tree states on Netgear Smart Switches. This private MIB enables network management systems to retrieve granular operational data and control parameters specific to Netgear's proprietary switching firmware that are not covered by standard IEEE MIBs.
The NETGEAR-SWITCHING-MIB provides vendor-specific extensions for monitoring and managing Layer 2 switching functions on Netgear network switches, including port status, MAC address table entries, and VLAN configurations. It enables SNMP-based retrieval of proprietary switching metrics not covered by standard IETF MIBs to facilitate granular fault isolation and traffic analysis within Netgear-managed infrastructure.
SNMP MIB module
Standard SNMP MIB module defining data structures for GSM7312-SWITCHING-MIB.