IPV6LOWPAN-MIB
The MIB module for monitoring 6lowpan entities. Copyright (C) The Internet Society 2007. This version of this MIB module is part of RFC XXXX; see the RFC itself for full legal notices.
Main OID:
lowpanMIB.1.3.6.1.2.1.1
27
Objects
Active
Status
4
Dependencies
Imported Objects
Objects
27 total| Object Name |
|---|
lowpanMIBThe MIB module for monitoring 6lowpan entities. Copyright (C) The Internet Society 2007. This version of this MIB module is part of RFC XXXX; see the RFC itself for full legal notices. MODULE-IDENTITY .1.3.6.1.2.1.1 |
lowpanNotifications OBJECT IDENTIFIER .1.3.6.1.2.1.1.0 |
lowpanObjects OBJECT IDENTIFIER .1.3.6.1.2.1.1.1 |
lowpanDeviceRoleThe device in 6lowpan can play three roles. coordinator(0) indicates that the device is a PAN Coordinator which is the primary controller of the PAN. Its a full-function device (FFD). It MAY initiate the synchronization of the entire 6LoWPAN by transmitting beacons. router(1) a FFD which has the capability of routing packets to the next hop device in 6LoWPAN. endDevice(2) RFD (Reduced function device) or FFD in a 6LoWPAN, which is neither the coordinator nor a router.ro Enumeration .1.3.6.1.2.1.1.1.1 |
lowpanDeviceCapabilitiesalternatePANcoordinator(0)- The alternate PAN coordinator subfield shall be set to 1 if the device is capable of becoming a PAN coordinator. Otherwise, the alternate PAN coordinator subfield shall be set to 0. deviceType(1) -The device type subfield shall be set to 1 if the device is an FFD. Otherwise, the device type subfield shall be set to 0 to indicate an RFD. powerSource(2)- The power source subfield shall be set to 1 if the device is receiving power from the alternating current mains. Otherwise, the power source subfield shall be set to 0. recieverOnWhenIdle(3) - The receiver on when idle shall be set to 1 if the device does not disable its receiver to conserve power during idle periods. Otherwise, the receiver on when idle subfield shall be set to 0. securityCapability(6)- The security capability subfield shall be set to 1 if the device is capable of sending and receiving MAC frames secured using the security suite. Otherwise the security capability subfield shall be set to 0. allocateAddress(7)- The allocate address subfield shall be set to 1 if the device wishes the coordinator to allocate a short address as a result of the association procedure. If this subfield is set to 0, the special short address of 0 x fffe shall be allocated to the device and returned through the association response command. In this case, the device shall communicate on the PAN using only its 64 bit extended address. BITS 4-5 are reserved.ro Bits .1.3.6.1.2.1.1.1.2 |
lowpanRoutingTableThe routing table entries of a device. SEQUENCE OF LowpanRoutingEntry .1.3.6.1.2.1.1.1.3 |
lowpanRoutingEntryThis entry represents a conceptual row in the routing table. It represents a single routing entry. LowpanRoutingEntry .1.3.6.1.2.1.1.1.3.1 |
lowpanRouteDestAddressThe 16-bit short address of destination of this route. LowpanShortAddress (LOWPAN-TC-MIB) .1.3.6.1.2.1.1.1.3.1.1 |
lowpanRouteNextHopAddressThe short address of the next hop which leads to the destination.ro LowpanShortAddress (LOWPAN-TC-MIB) .1.3.6.1.2.1.1.1.3.1.2 |
lowpanRouteProtocol6lowpan currently supports three routing protocols dymoLow(1) - Dynamic MANET On-demand routing for 6LoWPAN hiLow(2) - Hierarchical Routing over 6LoWPAN load(3) -Ad Hoc On-Demand Distance Vector Routing for 6lowpanro Enumeration .1.3.6.1.2.1.1.1.3.1.3 |
lowpanNeighborTableThe neighbor table entries of a device SEQUENCE OF LowpanNeighborEntry .1.3.6.1.2.1.1.1.4 |
lowpanNeighborEntryThis entry represents a conceptual row in the neighbor table. It represents a single neighbor table entry. LowpanNeighborEntry .1.3.6.1.2.1.1.1.4.1 |
lowpanNeighborPanIDThe Personal area network Identifier (PanID) of the neighbor entry.ro Unsigned32 .1.3.6.1.2.1.1.1.4.1.1 |
lowpanNeighborEUI64AddressThe EUI64 bit address of the neighbor entry. LowpanIEEEEUI64Address (LOWPAN-TC-MIB) .1.3.6.1.2.1.1.1.4.1.2 |
lowpanNeighborShortAddressThe 16-bit short address of the neighbor entry.ro LowpanShortAddress (LOWPAN-TC-MIB) .1.3.6.1.2.1.1.1.4.1.3 |
lowpanNeighborDeviceTypeThe device type of the neighbor entry.ro Enumeration .1.3.6.1.2.1.1.1.4.1.4 |
lowpanNeighborIsParentThe value 'true(1)' indicates that the neighbor is a topological parent of the device.ro TruthValue (SNMPv2-TC) .1.3.6.1.2.1.1.1.4.1.5 |
lowpanUseHierarchicalRoutingThe value 'true(1)' indicates that the entity uses tree based routing. 'false(2)' indicates that entity is not using tree based routing.ro TruthValue (SNMPv2-TC) .1.3.6.1.2.1.1.1.5 |
lowpanBroadcastSequenceNumberThe last value of the sequence number that was added to the 6lowpan broadcast or multicast frame.ro Unsigned32 .1.3.6.1.2.1.1.1.6 |
lowpanAckTimeoutThe maximum time allowed for retransmission of a broadcast messagerw Unsigned32 UNITS "milli-seconds" .1.3.6.1.2.1.1.1.7 |
lowpanBroadcastRetriesThe maximum number of retries allowed for a broadcast message.rw Unsigned32 .1.3.6.1.2.1.1.1.8 |
lowpanConformance OBJECT IDENTIFIER .1.3.6.1.2.1.1.2 |
lowpanGroups OBJECT IDENTIFIER .1.3.6.1.2.1.1.2.1 |
lowpanGeneralGroupA collection of objects for basic 6lowpan monitoring Unknown .1.3.6.1.2.1.1.2.1.1 |
lowpanCompliances OBJECT IDENTIFIER .1.3.6.1.2.1.1.2.2 |
lowpanCoreComplianceThe compliance statement for SNMP entities which implement the LOWPAN-MIB. Unknown .1.3.6.1.2.1.1.2.2.1 |
lowpanCoreReadOnlyComplianceThe compliance statement for SNMP entities which implement the LOWPAN-MIB without support for read-write (i.e. in read-only mode) . Unknown .1.3.6.1.2.1.1.2.2.2 |