FASTPATH-NSF-MIB
The FASTPATH-NSF-MIB manages and monitors Non-Stop Forwarding (NSF) state synchronization, switchover readiness, and protocol recovery status on Juniper Networks FastPath-based routing platforms. It exposes specific counters and status indicators for NSF-aware protocols (such as OSPF, IS-IS, and BGP) to verify continuous packet forwarding during control plane failover events.
Imported Objects
Objects
31 total| Object Name |
|---|
fastPathNsfThis MIB defines the objects used for FastPath to configure and report information and status of NSF features. MODULE-IDENTITY .1.3.6.1.4.1.4413.1.1.46 |
agentNsfTraps OBJECT IDENTIFIER .1.3.6.1.4.1.4413.1.1.46.0 |
agentNsfStackRestartCompleteSent when a the stack finishes restarting after a failover. NOTIFICATION-TYPE .1.3.6.1.4.1.4413.1.1.46.0.1 |
agentNsfUnitTableA table of Per-Unit configuration objects for NSF. SEQUENCE OF AgentNsfUnitEntry .1.3.6.1.4.1.4413.1.1.46.1 |
agentNsfUnitEntryEach Instance corresponds with a different unit managed by this agent. AgentNsfUnitEntry .1.3.6.1.4.1.4413.1.1.46.1.1 |
agentNsfUnitSupportIndicates if the unit supports the NSF feature.ro TruthValue (SNMPv2-TC) .1.3.6.1.4.1.4413.1.1.46.1.1.1 |
agentNsfGroup OBJECT IDENTIFIER .1.3.6.1.4.1.4413.1.1.46.2 |
agentNsfAdminStatusControls whether NSF is enabled on the unit/stack.rw Enumeration .1.3.6.1.4.1.4413.1.1.46.2.1 |
agentNsfOperStatusIndicates whether NSF is enabled on the unit/stack.ro Enumeration .1.3.6.1.4.1.4413.1.1.46.2.2 |
agentNsfLastStartupReasonThe type of activation that caused the software to start the last time. unknown: The switch rebooted for an unknown reason. power-on: The switch rebooted. This could have been caused by a power cycle or an administrative 'Reload' command. warm-admin-move: The administrator issued a command for the stand-by manager to take over. cold-admin-move: The administrator issued a command for the stand-by manager to take over, but the system was not ready for a warm-failover. warm-auto-restart: The primary management card restarted due to a failure, and the system executed a nonstop forwarding failover. cold-auto-restart: The system switched from the active manager to the backup manager and was unable to maintain user data traffic. This is usually caused by multiple failures occurring close togetherro Enumeration .1.3.6.1.4.1.4413.1.1.46.2.3 |
agentNsfTimeSinceLastRestartTime since the current management card became the active management card.ro TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.4413.1.1.46.2.4 |
agentNsfRestartInProgressWhether a restart is in progress. A restart is not considered complete until all hardware tables have been fully reconciled.ro TruthValue (SNMPv2-TC) .1.3.6.1.4.1.4413.1.1.46.2.5 |
agentNsfWarmRestartReadyWhether the initial full checkpoint has finished.ro TruthValue (SNMPv2-TC) .1.3.6.1.4.1.4413.1.1.46.2.6 |
agentNsfBackupConfigurationAgeAge of the configuration on the backup unit. The time since the running configuration was last copied to the backup unit.ro TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.4413.1.1.46.2.7 |
agentNsfInitiateFailoverTriggers an administrative failover to the backup unit.rw Enumeration .1.3.6.1.4.1.4413.1.1.46.2.8 |
agentCheckpointStatsGroup OBJECT IDENTIFIER .1.3.6.1.4.1.4413.1.1.46.3 |
agentCheckpointClearStatisticsWhen set to enable(1), resets checkpoint statistics.rw Enumeration .1.3.6.1.4.1.4413.1.1.46.3.1 |
agentCheckpointMessagesTotal number of checkpoint messages sent.ro Counter32 .1.3.6.1.4.1.4413.1.1.46.3.2 |
agentCheckpointBytesSize in bytes of the total ammount of checkpoint messages sent.ro Counter32 .1.3.6.1.4.1.4413.1.1.46.3.3 |
agentCheckpointTimeSinceCountersClearedIndicates how long since the Checkpoint counters have been cleared.ro TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.4413.1.1.46.3.4 |
agentCheckpointMessageRateIntervalIndicates the duration in seconds of the message rate interval.ro Unsigned32 UNITS "seconds" .1.3.6.1.4.1.4413.1.1.46.3.5 |
agentCheckpointMessageRateNumber of checkpoint messages received in the last interval defined by agentCheckpointMessageRateInterval.ro Gauge32 .1.3.6.1.4.1.4413.1.1.46.3.6 |
agentCheckpointHighestMessageRateHighest number of checkpoint messages received in an interval defined by agentCheckpointMessageRateInterval.ro Gauge32 .1.3.6.1.4.1.4413.1.1.46.3.7 |
agentNsfOspfGroup OBJECT IDENTIFIER .1.3.6.1.4.1.4413.1.1.46.4 |
agentNsfOspfSupportModerw Enumeration .1.3.6.1.4.1.4413.1.1.46.4.1 |
agentNsfOspfRestartIntervalrw Unsigned32 .1.3.6.1.4.1.4413.1.1.46.4.2 |
agentNsfOspfRestartStatusro Enumeration .1.3.6.1.4.1.4413.1.1.46.4.3 |
agentNsfOspfRestartAgero TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.4413.1.1.46.4.4 |
agentNsfOspfRestartExitReasonro Enumeration .1.3.6.1.4.1.4413.1.1.46.4.5 |
agentNsfOspfHelperSupportModerw Enumeration .1.3.6.1.4.1.4413.1.1.46.4.6 |
agentNsfOspfHelperStrictLSACheckingrw Enumeration .1.3.6.1.4.1.4413.1.1.46.4.7 |
More MIBs from Broadcom
Browse all BroadcomMIBs →SNMP MIB module
SNMP MIB module
The FASTPATH-ROUTING-MIB provides vendor-specific SNMP access to monitor and manage routing table entries, forwarding states, and interface statistics on Broadcom-based FastPath switching platforms. It exposes critical operational metrics including active route counts, protocol state transitions, and packet forwarding counters essential for troubleshooting Layer 3 forwarding performance on these proprietary hardware architectures.
The FASTPATH-QOS-DIFFSERV-PRIVATE-MIB enables monitoring and configuration of Quality of Service (QoS) Differentiated Services (DiffServ) policies, including traffic classification, marking, and queuing parameters, on Netgear FastPath-based networking hardware. This private module provides vendor-specific access to internal QoS state variables and counters that are not exposed in standard IETF DiffServ MIBs.
The EdgeSwitch-QOS-DIFFSERV-PRIVATE-MIB enables monitoring and configuration of Quality of Service (QoS) Differentiated Services (DiffServ) parameters, including traffic classification, queuing, and scheduling policies, on Ubiquiti EdgeSwitch hardware. This private MIB extension provides granular visibility into per-interface and per-queue traffic statistics and policy enforcement states not covered by standard DiffServ MIBs.
Standard SNMP MIB module defining data structures for QUANTA-LB6M-REF-MIB.