EdgeSwitch-UDLD-MIB
Imported Objects
Objects
13 total| Object Name |
|---|
fastPathUdldThe Ubiquiti Private MIB for FastPath UDLD. MODULE-IDENTITY .1.3.6.1.4.1.4413.1.1.54 |
agentUdldMIBObjects OBJECT IDENTIFIER .1.3.6.1.4.1.4413.1.1.54.1 |
agentUdldGlobal OBJECT IDENTIFIER .1.3.6.1.4.1.4413.1.1.54.1.1 |
agentUdldGlobalModeIndicates the mode of UDLDP feature on the device.
enable
enabled on the device.
disable
disabled on the device.rw Enumeration .1.3.6.1.4.1.4413.1.1.54.1.1.1 |
agentUdldMessageIntervalIndicates interval in seconds at which each port
sends a packet to all of its neighbors at
steady state when the link has been identified as
bidirectional.rw INTEGER .1.3.6.1.4.1.4413.1.1.54.1.1.2 |
agentUdldTimeoutIntervalIndicates Timeout interval in seconds.rw INTEGER .1.3.6.1.4.1.4413.1.1.54.1.1.3 |
agentUdldResetResets all interfaces that have been shutdown by UDLD. On read OID will always be 0.rw Enumeration .1.3.6.1.4.1.4413.1.1.54.1.1.4 |
agentUdldInterface OBJECT IDENTIFIER .1.3.6.1.4.1.4413.1.1.54.1.2 |
agentUdldInterfaceTableThe table containing the status
of UDLDP on the device's interfaces. SEQUENCE OF UdldInterfaceEntry .1.3.6.1.4.1.4413.1.1.54.1.2.1 |
agentUdldInterfaceEntryAn entry exists for each interface that supports
UDLDP. UdldInterfaceEntry .1.3.6.1.4.1.4413.1.1.54.1.2.1.1 |
agentUdldInterfaceOperStatusThis mib object contains the following values,
which has the meaning as:
'shutdown' - An Unidirectional link has been
detected and the port has been disabled.
'undetermined' - Unidirectional Link Detection
protocol has not collected enough
information to determine if the
link is bidirectional or not.
'biDirectional' - A bidirectional link has been
detected.
'notApplicable' - Unidirectional Link Detection
Protocol is disabled.
'undetermined-LinkDown' - The port would transition into
this state when the port link physically
goes down due to any reasons other than
the port been put into D-Disable mode
by UDLD protocol on the switch.ro Enumeration .1.3.6.1.4.1.4413.1.1.54.1.2.1.1.1 |
agentUdldInterfaceAdminModeIndicates the Administrative mode of Unidirectional
Link Detection Protocol Feature configured on this
interface.
enable
enabled on this interface.
disable
disabled on this interface.rw Enumeration .1.3.6.1.4.1.4413.1.1.54.1.2.1.1.2 |
agentUdldInterfaceAggresiveMode"Indicatesrw TruthValue (SNMPv2-TC) .1.3.6.1.4.1.4413.1.1.54.1.2.1.1.3 |
More MIBs from Broadcom
Browse all BroadcomMIBs →SNMP MIB module
SNMP MIB module
The FASTPATH-ROUTING-MIB provides vendor-specific SNMP access to monitor and manage routing table entries, forwarding states, and interface statistics on Broadcom-based FastPath switching platforms. It exposes critical operational metrics including active route counts, protocol state transitions, and packet forwarding counters essential for troubleshooting Layer 3 forwarding performance on these proprietary hardware architectures.
The FASTPATH-QOS-DIFFSERV-PRIVATE-MIB enables monitoring and configuration of Quality of Service (QoS) Differentiated Services (DiffServ) policies, including traffic classification, marking, and queuing parameters, on Netgear FastPath-based networking hardware. This private module provides vendor-specific access to internal QoS state variables and counters that are not exposed in standard IETF DiffServ MIBs.
The EdgeSwitch-QOS-DIFFSERV-PRIVATE-MIB enables monitoring and configuration of Quality of Service (QoS) Differentiated Services (DiffServ) parameters, including traffic classification, queuing, and scheduling policies, on Ubiquiti EdgeSwitch hardware. This private MIB extension provides granular visibility into per-interface and per-queue traffic statistics and policy enforcement states not covered by standard DiffServ MIBs.
Standard SNMP MIB module defining data structures for QUANTA-LB6M-REF-MIB.