ETH-OPT-MIB
AI MIB Summary
Standard SNMP MIB module defining data structures for ETH-OPT-MIB.
40
Objects
Active
Status
2
Dependencies
Imported Objects
Objects
40 total| Object Name |
|---|
codex OBJECT IDENTIFIER .1.3.6.1.4.1.449 |
RFC1155-SMI Unknown .1.3.6.1.4.1.449 |
cdxProductSpecific OBJECT IDENTIFIER .1.3.6.1.4.1.449.2 |
cdx6500 OBJECT IDENTIFIER .1.3.6.1.4.1.449.2.1 |
cdx6500Configuration OBJECT IDENTIFIER .1.3.6.1.4.1.449.2.1.2 |
cdx6500CfgProtocolGroup OBJECT IDENTIFIER .1.3.6.1.4.1.449.2.1.2.1 |
cdx6500PCTPortProtocolGroup OBJECT IDENTIFIER .1.3.6.1.4.1.449.2.1.2.1.1 |
cdx6500PPCTdot3PortTableThis table contains Ethernet interface parameters and
state variables, one entry per 802.3 interface. SEQUENCE OF Cdx6500PPCTdot3PortEntry .1.3.6.1.4.1.449.2.1.2.1.1.8 |
cdx6500PPCTdot3PortEntryA list of Ethernet status and parameter
values for an 802.3 interface. Cdx6500PPCTdot3PortEntry .1.3.6.1.4.1.449.2.1.2.1.1.8.1 |
cdx6500dot3IfIndexThis object is the port number for the Interface.ro INTEGER .1.3.6.1.4.1.449.2.1.2.1.1.8.1.1 |
cdx6500dot3LanCableTypeTwo LAN connectors are provided and only one connector,
selected by software, is active at any given time.
This parameter specifies the type of cable and therefore
which connector is used for the LAN interface as follows:
utp: Unshielded Twisted Pair (RJ-45)
aui: Attachment Unit Interface (DB-15)rw Enumeration .1.3.6.1.4.1.449.2.1.2.1.1.8.1.2 |
cdx6500dot3PortMacAddressSpecifies the MAC address of the LAN port.
The entered value of 00-00-00-00-00-00 will be replaced by
the Burned In Address (BIA) if the LAN hardware is present.rw MacAddress (SNMPv2-TC) .1.3.6.1.4.1.449.2.1.2.1.1.8.1.3 |
cdx6500dot3TransmitQueueLimitNumber of frames that can be queued on the LAN transmitter
before any frame is dropped.rw INTEGER .1.3.6.1.4.1.449.2.1.2.1.1.8.1.4 |
cdx6500dot3CollisionSensitivityThis parameter specifies the width required of the collision
detection signal, in bit times, before it is recognized that
a collision has occurred.rw INTEGER .1.3.6.1.4.1.449.2.1.2.1.1.8.1.5 |
cdx6500dot3CarrierSensitivityThis parameter specifies the width required of the carrier
sense signal in bit times, before it is recognized as being
active. Carrier sense deactivation is recognized immediately.
This capability is useful in noisy cable environments.rw INTEGER .1.3.6.1.4.1.449.2.1.2.1.1.8.1.6 |
cdx6500dot3BridgeLinkNumThis parameter specifies the bridge link number
associated with this LAN port.rw INTEGER .1.3.6.1.4.1.449.2.1.2.1.1.8.1.7 |
cdx6500dot3RouterIfNumThis parameter specifies the router interface number
associated with this LAN port.rw INTEGER .1.3.6.1.4.1.449.2.1.2.1.1.8.1.8 |
cdx6500dot3DuplexModeThis parameter specifies whether this LAN port should run in
either Half-Duplex or Full-Duplex mode.rw Enumeration .1.3.6.1.4.1.449.2.1.2.1.1.8.1.9 |
cdx6500Statistics OBJECT IDENTIFIER .1.3.6.1.4.1.449.2.1.3 |
cdx6500StatProtocolGroup OBJECT IDENTIFIER .1.3.6.1.4.1.449.2.1.3.1 |
cdx6500PSTPortProtocolGroup OBJECT IDENTIFIER .1.3.6.1.4.1.449.2.1.3.1.1 |
cdx6500PPSTdot3PortTableA table containing Ethernet statistics, one entry per
802.3 interface. All the statistics are defined using
the syntax Counter as 32-bit wrap around counters. Thus,
if an interface's hardware maintains these statistics in
16-bit counters, then the agent must read the hardware's
counters frequently enough to prevent loss of significance,
in order to maintain 32-bit counters in software. SEQUENCE OF Cdx6500PPSTdot3Entry .1.3.6.1.4.1.449.2.1.3.1.1.8 |
cdx6500PPSTdot3PortEntryAn entry contains the 802.3 statistics
for a particular interface. Cdx6500PPSTdot3Entry .1.3.6.1.4.1.449.2.1.3.1.1.8.1 |
cdx6500dot3StatsIfIndexThe value of this object identifies the 802.3 interface
for which this entry contains management information. It
is also the port number of the interface.ro INTEGER .1.3.6.1.4.1.449.2.1.3.1.1.8.1.1 |
cdx6500dot3StatsPortTypeThe configured value of the Port type.ro Enumeration .1.3.6.1.4.1.449.2.1.3.1.1.8.1.2 |
cdx6500dot3StatsRxShortFramesThis counter is incremented when the LAN port observes
a receive or transmitted frame which is less than 18 bytes.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.3 |
cdx6500dot3StatsRxCollisionsThis counter is incremented when the LAN port observes
collisions.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.4 |
cdx6500dot3StatsRxLongFramesThis counter is incremented when the LAN port observes a
frame that can not be forwarded because of excessive length.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.5 |
cdx6500dot3StatsTxDiscardsThis counter is incremented when the LAN port discards the
frame because the transmit queue exceeds the maximum queue
length.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.6 |
cdx6500dot3StatsDataBytesRxThis counter is incremented for each data byte received by
the LAN port.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.7 |
cdx6500dot3StatsDataBytesTxThis counter is incremented for each data byte transmitted
by the LAN port.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.8 |
cdx6500dot3StatsPortStatusIndicates the status of the LAN port.
newvalDisabled : same functionality as 'disabled', new enumeration
added for RFC1155 compatibility.ro Enumeration .1.3.6.1.4.1.449.2.1.3.1.1.8.1.9 |
cdx6500dot3StatsLastStatResetTime stamp when the statistics were last reset.ro DisplayString (SNMPv2-TC) .1.3.6.1.4.1.449.2.1.3.1.1.8.1.10 |
cdx6500dot3StatsClearStatsThis is the command to reset the LAN port statistics.rw Enumeration .1.3.6.1.4.1.449.2.1.3.1.1.8.1.11 |
cdx6500dot3StatsCommandThis is a control for the 802.3 port.
enable : will enable the port.
boot : will boot the port.
disable : will disable the port.rw Enumeration .1.3.6.1.4.1.449.2.1.3.1.1.8.1.12 |
cdx6500dot3StatsframesinThis counter is incremented for each frame
received by the LAN port.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.13 |
cdx6500dot3StatsframesoutThis counter is incremented for each frame
transmitted by the LAN port.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.14 |
cdx6500dot3StatsfpsinThis stat specifies the number of frames
per second received by the LAN port.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.15 |
cdx6500dot3StatsfpsoutThis stat specifies the number of frames
per second transmitted by the LAN port.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.16 |
cdx6500dot3StatshadiscardsThis counter specifies the number of frames
the HA discarded.ro Counter .1.3.6.1.4.1.449.2.1.3.1.1.8.1.17 |