CNT246-MIB
This defines the CNT Transport MIB. The Transport layer provides network link for CNT proprietary traffic.
Main OID:
cnt2Transport.1.3.6.1.4.1.333.2.4.6
37
Objects
Active
Status
2
Dependencies
Imported Objects
Objects
37 total| Object Name |
|---|
cnt2TransportThis defines the CNT Transport MIB. The Transport layer provides network link for CNT proprietary traffic. MODULE-IDENTITY .1.3.6.1.4.1.333.2.4.6 |
cnt2TransportTableA list of Transport network link entries. SEQUENCE OF Cnt2TransportEntry .1.3.6.1.4.1.333.2.4.6.1 |
cnt2TransportEntryA Transport network link entry. Cnt2TransportEntry .1.3.6.1.4.1.333.2.4.6.1.1 |
cnt2TransportSlotIndexThe slot index for this Transport entryro Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.1 |
cnt2TransportIndexThe relative index of the bus number in this Transport entryro Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.2 |
cnt2TransportBusThe network link bus numberro Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.3 |
cnt2TransportVidThe virtual circuit number VCI. If ATM is used, make sure this Vid is configured the same as the VCI. Failure to do so will cause unexpected resultsro Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.4 |
cnt2TransportLinkTypeThe Link type supported by the CNT Transport layer.ro Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.5 |
cnt2TransportLinkDescThe description of the network link suported by the CNT Transport layerro DisplayString (SNMPv2-TC) .1.3.6.1.4.1.333.2.4.6.1.1.6 |
cnt2TransportLinkStatusThe network link's status. The link status indicates if there is communication between the local node and the remote node.ro Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.7 |
cnt2TransportIPtosPrecedenceThe service precedence of IP Type of Service use by this link. There is an 8 bit field in an IP datagram that specifies the type of service a datagram is requesting (or hinting). It may then be used by the network to determine paths and precedence for a given datagram. The specific bits used may vary depending on the network (see RFC 791 for more details). The IpServiceType attribute can be used on a per circuit basis to specify the bits to be set in the IP datagram's service type field. Each Transport IP datagram destined for the DestionationIpAddress will have this field set. This attributes only applicable to IP providers. The service precedence is in bit 0-2 of the 8 bit IP Type of Service field.rw Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.8 |
cnt2TransportIPtosDelayThe IP Type of Service Delay option use by this link. The Delay bit is in bit 3 of the 8 bit IP Type of Service field.rw Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.9 |
cnt2TransportIPtosThruputThe IP Type of Service Throughput option use by this link. The Throughput bit is in bit 4 of the 8 bit IP Type of Service field.rw Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.10 |
cnt2TransportIPtosRelibilityThe IP Type of Service Relibility option use by this link. The Relibility bit is in bit 5 of the 8 bit IP Type of Service field.rw Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.11 |
cnt2TransportRemoteIpThe remote IP address. This address is set when Transport is configured.ro IpAddress .1.3.6.1.4.1.333.2.4.6.1.1.12 |
cnt2TransportProtocolThe protocol used by this link. At the moment the only protocol is SAP.ro Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.13 |
cnt2TransportCompressionOptionReflects whether compression option is turned on/off.rw Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.14 |
cnt2TransportMaxXmitRateThe Maximum Transfer Rate of this link.rw Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.15 |
cnt2TransportResetTimeThe time, in seconds, when the stats was last reset.ro TimeTicks (SNMPv2-SMI) .1.3.6.1.4.1.333.2.4.6.1.1.16 |
cnt2TransportInPktsThe number of packets transmitted to the linkro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.17 |
cnt2TransportInOctetsThe number of bytes transmitted to the linkro Counter64 .1.3.6.1.4.1.333.2.4.6.1.1.18 |
cnt2TransportOutPktsThe number of packets transmitted out from the linkro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.19 |
cnt2TransportOutOctetsThe number of bytes transmitted out from the linkro Counter64 .1.3.6.1.4.1.333.2.4.6.1.1.20 |
cnt2TransportRexmitThe number of packets being retransmittedro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.21 |
cnt2TransportOosHighThe number of out of sequence packets receivedro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.22 |
cnt2TransportStatsResetSetting this will result the Transport statistic to be resetrw Enumeration .1.3.6.1.4.1.333.2.4.6.1.1.23 |
cnt2TransportRawOutOctetsThe number of bytes transmitted out from the lower interface of Transport layer. This is the amount of data after Compression plus Transport header.ro Counter64 .1.3.6.1.4.1.333.2.4.6.1.1.24 |
cnt2TransportRawInOctetsThe number of bytes received in from the lower interface of Transport layer. This is the amount of data after Compression plus Transport header.ro Counter64 .1.3.6.1.4.1.333.2.4.6.1.1.25 |
cnt2TransportWindowSizeThe current window size, value is number buffers outstanding on the connectionro Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.26 |
cnt2TransportSegmentSizeRange from (0 to 65532) If this value is non-zero, this value is used for segmentation. If equal to 0, then TransportSegmentSizeHi is what being used.ro Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.27 |
cnt2TransportSegmentSizeHiRange from (0 to 65532) If this value is used when TransportSegmentSize is set to 0. This value is passed in from user layer's MTU size.ro Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.28 |
cnt2TransportRoundTripTimerThe current round trip timer. each count is in 50msec.ro Integer32 .1.3.6.1.4.1.333.2.4.6.1.1.29 |
cnt2TransportHoldCountThe current hold count.ro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.30 |
cnt2TransportHoldCountRatio1Incremented when an ack is received and there is no data on the hold queue and there is no outstanding (unacked) data. It indicates that transmission is idled until more data is received from the user.ro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.31 |
cnt2TransportHoldCountRatio2Incremented when an ack is received and there is no data on the hold queue but there is outstanding (unacked) data.ro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.32 |
cnt2TransportHoldCountRatio3Incremented when an ack is received and there is data on the hold queue ready to be sent.ro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.33 |
cnt2TransportTotalDisconnectTotal disconnects at Transport Layer.ro Counter32 .1.3.6.1.4.1.333.2.4.6.1.1.34 |