A3Com-Mip-r1-MIB
AI MIB Summary
Standard SNMP MIB module defining data structures for A3Com-Mip-r1-MIB.
26
Objects
Active
Status
2
Dependencies
Imported Objects
Objects
26 total| Object Name |
|---|
a3Com OBJECT IDENTIFIER .1.3.6.1.4.1.43 |
RFC1155-SMI Unknown .1.3.6.1.4.1.43 |
brouterMIB OBJECT IDENTIFIER .1.3.6.1.4.1.43.2 |
a3ComMIP OBJECT IDENTIFIER .1.3.6.1.4.1.43.2.27 |
a3ComMipSConfig OBJECT IDENTIFIER .1.3.6.1.4.1.43.2.27.1 |
a3ComMipControlIf this object is set to enabled(1), then multicast IP routing is in
service. If it is set to disabled(2), then multicast IP routing is
turned off.rw Enumeration .1.3.6.1.4.1.43.2.27.1.1 |
a3ComMipCConfig OBJECT IDENTIFIER .1.3.6.1.4.1.43.2.27.2 |
a3ComMipPortTableThis table contains entries of parameters associated with every port
or tunnel. SEQUENCE OF A3ComMipPortEntry .1.3.6.1.4.1.43.2.27.2.1 |
a3ComMipPortEntryEach entry contains information for a spcified port or tunnel. A3ComMipPortEntry .1.3.6.1.4.1.43.2.27.2.1.1 |
a3ComMipPortIndexThe port number or tunnel ID of which this entry applies. The
tunnel ID starts with 1025 and end with 1056, i.e. total tunnel
number is limited to 32.ro INTEGER .1.3.6.1.4.1.43.2.27.2.1.1.1 |
a3ComMipPortQueryIntervalThis object specifies the time interval in seconds that a Host
Query message is sent to the attached subnet to request for the
local group membership. It also derives the Membership Expiration
time which is set to two times value of this object plus 20
seconds. This object cannot be applied on tunnel port.rw INTEGER (5 .. 5400) .1.3.6.1.4.1.43.2.27.2.1.1.2 |
a3ComMipPortThresholdThis object specifies the minimum IP TTL required for a multicast
datagram to be forwarded to the given port or tunnel.rw INTEGER (1 .. 255) .1.3.6.1.4.1.43.2.27.2.1.1.3 |
a3ComMipPortQuerierThis object specifies if the system is responsible for sending out
Host Query messages on this port. If the value is yes(1) then the
system is the designated router on the subnet this port connects to
and the system is sending out Host Query messages periodically on
that port. This object must be set to value no(2) for tunnel port.ro Enumeration .1.3.6.1.4.1.43.2.27.2.1.1.4 |
a3ComMipPortPaceModeThis object is used to control PACE mode. If set to enabled(1),
the multicast packets will be sent out with the Universal/Local bit
set, or Priority MAC. If set to disabled(2) the Universal/Local bit
is clear, or Interactive MAC.rw Enumeration .1.3.6.1.4.1.43.2.27.2.1.1.5 |
a3ComMipLocalGroupTableThis table contains group membership information of each attached
subnet. SEQUENCE OF A3ComMipLocalGroupEntry .1.3.6.1.4.1.43.2.27.2.2 |
a3ComMipLocalGroupEntryEach entry contains a group membership information associated with
a specific port. A3ComMipLocalGroupEntry .1.3.6.1.4.1.43.2.27.2.2.1 |
a3ComMipLocalGroupPortThis object specifies the port number to which this entry applies.ro INTEGER .1.3.6.1.4.1.43.2.27.2.2.1.1 |
a3ComMipLocalGroupIpAddrThis object specifies group's address presents on the specified
port. If the port is configured as a tunnel, there will be no group
address associated with it.ro IpAddress .1.3.6.1.4.1.43.2.27.2.2.1.2 |
a3ComMipLocalGroupTypeThis object specifies the type of local group. This object can only
be set to 'static' by SET command, and if the local group is learned
from IGMP, it is set to 'igmp'.ro Enumeration .1.3.6.1.4.1.43.2.27.2.2.1.3 |
a3ComMipLocalGroupStatusThis object is used to add and delete entries in this table. See
the definition of RowStatus for detail.rw RowStatus (SNMPv2-TC) .1.3.6.1.4.1.43.2.27.2.2.1.4 |
a3ComMipSmdsGroupTableThis table contains a set of IP network address and SMDS group address
mapping. SEQUENCE OF A3ComMipSmdsGroupEntry .1.3.6.1.4.1.43.2.27.2.3 |
a3ComMipSmdsGroupEntryEach entry contains an IP network address to SMDS group address mapping. A3ComMipSmdsGroupEntry .1.3.6.1.4.1.43.2.27.2.3.1 |
a3ComMipSmdsGroupIpAddrThis is an IP network address for which there is a corresponding
SMDS group address.ro IpAddress .1.3.6.1.4.1.43.2.27.2.3.1.1 |
a3ComMipSmdsGroupMediaAddrThis is the SMDS group address that corresponds to the IP network
address identified by a3ComMipSmdsGroupIpAddr.rw OCTET STRING ( SIZE(8) ) .1.3.6.1.4.1.43.2.27.2.3.1.2 |
a3ComMipSmdsGroupStatusThis object is used to add and delete entries in this table. See
the definition of RowStatus for detail.rw RowStatus (SNMPv2-TC) .1.3.6.1.4.1.43.2.27.2.3.1.3 |
a3ComMipData OBJECT IDENTIFIER .1.3.6.1.4.1.43.2.27.3 |